[SantaMonicaHelp]

Here are the requirements for building a UAS.

Screen material:

1)
Use plastic canvas as the algae screen. Remember to roughen it up properly using a wood saw or hole saw. You can get plastic canvas at craft store (under sewing section) or sewing store or online at places like www.everythingplasticcanvas.com or ebay. Screen should look like this:




Lighting

2)
The lighting needs to be 1 watt per square inch (6.25 square cm) of screen material. A 3 by 4 inch screen is 12 square inches not 24. Make sure you have enough wattage and use a reflector if the light doesnot focus on screen. For fluorescent bulbs, it needs to have a spectrum of 2700k-3000k. For LEDs, it needs to be red 660nm. You can cut the wattage in half if you are using LED lights. In order for algae to grow, make sure that the light is on for 18 hours a day. Here are some bulbs and reflector type:




Bubbles:

3)
The bubbles need to be rapid and large and distributed through out the screen evenly for algae to grow. The best way to do this is by slicing the air tubing. Make sure the air pump is good so that the bubbles can constantly flow across the screen for 24 hours a day. This is why you need bubbles: